2-Wire Intercom & Tally Breakout Cable For Select Sony, Panasonic & Ikegami CCU's.
DB25 Male To 5 XLRs
This Cable Brings Out The Following Connections To 3pin XLRs:
- Eng and Production In/Out** (Choose either (2) 3pin XLR Males or Females) [ENG I/O & PROD I/O] (**2-Wire I/O is separated into 2 XLRs, one XLR for ENGINEERING I/O and one XLR for PRODUCTION I/O)
- Program 1 In (3pin XLR Female) [PGM-1-In]
- Tally Red (3pin XLR Male) [TALLY-RED]
- Tally Green (3pin XLR Male) [TALLY-GRN]
For versions with a single XLR for ENG/PROD In/Out see here.
Intercom and Tally Breakout Adapter Cable
Standard length 3 ft. (custom lengths and/or custom XLR genders available). These cables are made in-house and are made upon order.
Works with Sony CCU's:
- CCU-550 (CCU550)
- CCU-TX50 (CCUTX50)
- HDCU-1000 (HDCU1000)
- HDCU-1500 (HDCU1500)
- HDCU-3300 (HDCU3300)
- HXCU-100 (HXCU100)
- HXCU-D70 (HXCUD70)
- HXCU-FB70 (HXCUFB70)
- HXCU-FB80 (HXCUFB80)
- HXCU-FZ90 (HXCUFZ90)
- HSCU-300 (HSCU300)
- And Similar Models
Works with Panasonic CCU's:
- AKHCU200P, AK-HCU200P (PS)
- AKHCU250P, AK-HCU250P (PJ, PS, PSJ)
- AKUCU500P, AK-UCU500P (PS)
- AKUCU600P, AK-UCU600P (PJ, PS, PSJ)
- And Similar Models
Works With Ikegami CCU's:
- BST-55 (BST55)
- And Similar Models
This cable is not compatible with the following old CCU models: CCU350, CCU355, CCUTX7
Tally XLR wiring: Tally XLR's are wired Pin2: Tally-X, Pin3: Tally-Y. The normal procedure to turn on a Tally light would be to short XLR pins 2 & 3 which completes (closes) the circuit and therefore turns on the Tally (some CCU's may differ, refer to your CCU's service manual for complete information).
Please note that not all CCU's, intercom systems & tally systems are capable of utilizing all connection types, so please refer to your system's specifications for more information on capabilities, configuration and use.
