Countryman B3P*FF05* Lavalier Mic With 3pin XLR Male For Hard Wired Phantom Power Use

The Type B3 Is A Very Small, Round, Omnidirectional Electret Microphone. It Has Special Features That Allow It To Withstand Moisture And Makeup When Placed In The Hair Or On The Body.

Features:
Extremely Small- Looks Great When You Want To See It. Hides Easily When You Don't.

Water Resistant: The B3 Withstands Moisture And Perspiration. It Will Even Survive An Overnight Bath In Your Favorite Cola Beverage.

Makeup Resistant: The Protective Cap On The B3 Is Easily Removed For Cleaning Or Replacement When Clogged With Makeup.

Low Handling Noise: With Kevlar Reinforced Cable And An Ultra Thin Diaphragm, The B3 Sets A New Standard For Low Handling Noise.

Selectable High Frequency Response: Protective Caps Change High Frequency Response.

Handles High Sound Levels: Up To 150db Spl On 48V Phantom Power

Available In Five Colors: Black, White, Light Skin, Cocoa, Gray

Specifications:
---------------------
Compatibility:
Designed To Operate With Any Balanced Microphone Input Providing Phantom Power

Frequency Response:
20hz To 20khz +- 3db

Sensitivity:
(2k Ohm Load): 10mv/Pa For P/N B3p4ff05XXX, 1mv/Pa For P/N B3p6ff05XXX

Equivalent Acoustic Noise:
24db Spl A-Weighted

Maximum Sound Pressure:
150 Db (48V, 1mv/Pa Mike)

Power Requirements:
9v To 48V Phantom (4ma @ 48V)

Output Impedance:
600 Ohms, Balanced

Output Connector:
XLR-3 Male (Contains Preamp)

Dimensions:
.23" X .18" (5.8mm X 4.6mm)

Weight:
.012 Oz (.34 G)

Supplied Accessories:
Carrying Case, Tie Clip And Wind Screen.

The Type B3 Is A Very Small, Round, OmniDirectional Electret Microphone. It Has Special Features That Allow It To Withstand Moisture And Makeup When Placed In The Hair Or On The Body. Features: Extremely Small- Looks Great When You Want To See It. Hides Easily When You Don't. Water Resistant: The B3 Withstands Moisture And Perspiration. It Will Even Survive An Overnight Bath In Your Favorite Cola Beverage. Makeup Resistant: The Protective Cap On The B3 Is Easily Removed For Cleaning Or Replacement When Clogged With Makeup. Low Handling Noise: With Kevlar Reinforced Cable And An Ultra Thin Diaphragm, The B3 Sets A New Standard For Low Handling Noise. Selectable High Frequency Response: Protective Caps Change High Frequency Response. Handles High Sound Levels: Up To 150db Spl On 48V Phantom Power Available In Five Colors: Black, White, Light Skin, Cocoa, Gray The B3 Comes Supplied With The +0db Protective Cap Installed On The Mic. Specifications: --------------------- Compatibility: Designed To Operate With Any Wireless Transmitter That Can Supply Microphone Power. Frequency Response: 20hz To 20khz +- 3db Sensitivity (10k Ohm Load): 6mv/Pa Standard Gain 2mv/Pa "Red Band" High Spl Equivalent Acoustic Noise: 24db Spl A-Weighted Maximum Sound Pressure: 140 Db (5v, "Red Band" Mike) Power Requirements: 3 To 12 Volts @ 200ua Output Impedance: 2k Ohms Output Connector: Pigtails Or Connector To Match Transmitter Dimensions: .23" X .18" (5.8mm X 4.6mm) Weight: .012 Oz (.34 G) Cable Length: Approximately 60" (5 ft.) Supplied Accessories: Carrying Case, Tie Clip And Windscreen